DESCRIPTION
Specifications: Item Name: Whoop and toothpick 2-IN-1 FPV Racer Drone; Wheelbase: 65mm; Size: 80mm*80mm*30mm; Weight: 17.5g (without battery). Features: The lightest 1S Whoop and Toothpick 2-IN-1 fpv drone. Comes with tooth pick frame for convert. Powerful and efficiency. The lightest 1s AIO 5IN1 F4 flight controller. New Unibell SE0702 brushless motors with pcb wire board. Built-in OPENVTX up to 400mw. Low profile Canopy design. Motor: Mode: SE0702 KV23000; Configu-ration: 9N12P; Stator Diamter: 7mm; Stator Length: 2mm; Shaft Diameter: Φ1mm; Motor Dimension(Dia.*Len): Φ9.5mm*14mm; Weight(g): 1.5g; No.of Cells(Lipo): 1S only. Propeller: Weight: 0.19g; Material: PC; Pitch: 1 inch; Props Dia: 30mm; Center Hole Dia: 1mm. Flight controller: (ELRS SPI RX version)DiamondF4 ELRS FC Firmware target: CrazybeeF4SX1280; (Frsky SPI RX version) DiamondF4 FR FC Firmware target: CrazybeeF4FR; MCU: STM32F411CEU6 (100MHZ, 512K FLASH); Sensor: MPU-6000 or ICM20689 or BMI270(SPI connection); Original whoop size compatible; Power supply: 1S battery input (DC 2.9V-4.35V); Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready; Built-in Betaflight OSD(SPI Control); Built-in 5.8G OPEN VTX; Built-in SPI ELRS V2.0/Frsky receiver; Built-in 5V 1A BEC. Onboard 4in1 ESC: MCU upgraded to EFM8BB21; Power supply: 1S LiPo/LiPo HV; Current: 5A continuous peak 6A (3 seconds); Support BLHeliSuite programmable; Factory firmware: O_H_50_REV16_8.HEX; Default protocol: DSHOT600. Onboard SPI ExpressLRS 2.4GHz Receiver: Packet Rate option: 50Hz/150Hz/250Hz/500Hz; ExpressLRS Firmware version: V2.0; RF Frequency: 2.4GHz; Antenna : Enameled copper wire antenna; Telemetry output Power: <12dBm; Receiver protocol: SPI ExpressLRS; Compatible with ExpressLRS V2.0 TX Module; Couldn't flash separately ExpressLRS firmware. Onboard Frsky SPI D8 receiver Version: SPI BUS receiver Frsky D8 compatible; Compatible Non EU transmitter D8 model; Channels: 8ch; Failsafe support; No ground interference ( Transmitter and receiver 1 m from the ground): 200m~300m. Onboard 5.8g OPENVTX: Firmware version: OPENVTX; Smartaudio v2.1; PIT Mode support; RCE Mode support; Channels: 48ch; Transmitting Power: 0/RCE/25mw/100mw/400mw; Power supply: DC 5V; Current (5v): <650ma (400mw). Runcam Nano3: Model: RunCam Nano 3; Image Sensor: 1/3' CMOS; Horizontal Resolution: 800TVL; Lens: 2.3mm(M6.5) FOV 140°; Signal System: NTSC; S/N Ratio: >50dB; Electronic Shutter Speed: Auto; Auto Gain Control (AGC): Auto; Min. Illumination: 0.01Luxat1.2F; D-WDR: Auto; Day/Night: Color; Power: DC 3-5.5V; Current: 110mAat5V 120mAat3.3V; Housing Material: ABS; Net Weight: 1.2g; Dimensions: L14mm*W14mm*H9mm. Lipo Battery: Capacity: 300mAh; Voltage: 3.8v; Continuous Discharge Rate: 30C; Size: 57mmx12mmx7mm; Weight: 7.5g; Connector: PH2.0.
